* Add ->mwdma_mask and ->swdma_mask to ide_pci_device_t.
* Set ide_hwif_t DMA masks using DMA masks from ide_pci_device_t in
setup-pci.c::ide_pci_setup_ports() (iff DMA base is valid and ->init_hwif
method may still override them).
* Convert IDE PCI host drivers to use ide_pci_device_t DMA masks.
While at it:
* Use ATA_{UDMA,MWDMA,SWDMA}* defines.
* hpt34x.c: add separate ide_pci_device_t instances for HPT343 and HPT345.
* serverworks.c: fix DMA masks being set before checking DMA base.
v2:
* Add missing masks to DECLARE_GENERIC_PCI_DEV() macro.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Documentation doesn't mention SWDMA and moreover all timings used
for SWDMA modes were over-clocked when compared to ATA spec.
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Add IDE_HFLAG_NO_LBA48[_DMA] host flags, use it instead of hwif->no_lba48[_dma]
and then remove no longer needed hwif->no_lba48[_dma]. As a side-effect
this change fixes hwif->no_lba48_dma not being restored by ide_hwif_restore().
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
* Make ide_pci_device_t.host_flags u32 and add IDE_HFLAG_CS5520 host flag.
* Pass ide_pci_device_t *d to setup-pci.c::ide_get_or_set_dma_base()
and use d->name instead of hwif->cds->name.
* Set IDE_HFLAG_CS5520 host flag in cs5520 host driver and use it in
ide_get_or_set_dma_base() to find out which PCI BAR to use, remove no longer
needed cs5520.c::cs5520_init_setup_dma() and ide_pci_device_t.init_setup_dma.
This fixes PCI bus-mastering not being checked for CS5510/CS5520 hosts.
v2:
* It is wrong to check simplex bits on CS5510/CS5520 as v1 did.
(Noticed by Alan).
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Add IDE_HFLAG_NO_{DMA,AUTODMA} host flags. Convert all host drivers using
ide_pci_device_t to use these flags instead of d->autodma and then remove no
longer needed d->autodma.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Add IDE_HFLAG_BOOTABLE host flag and IDE_HFLAG_OFF_BOARD define. Convert
all host drivers using ide_pci_device_t to use IDE_HFLAG_{BOOTABLE,OFF_BOARD}
instead of d->bootable and then remove no longer needed d->bootable.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Add IDE_HFLAG_NO_ATAPI_DMA host flag and set it in host drivers which
don't support ATAPI DMA. Then remove no longer needed hwif->atapi_dma.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
* Add DECLARE_GENERIC_PCI_DEV() macro to generic IDE PCI host driver
and use it to cleanup generic_chipsets[].
* Remove dead/obsolete code while at it.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
The cs5535 uses an incorrect construct to access the other drive of a pair,
causing it to access beyond an array boundary on the secondary interface.
This fixes it by using the new ide_get_paired_drive() helper instead.
Bart: patch description fixes
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Andrew Morton <akpm@osdl.org>
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
The siimage uses an incorrect construct to access the other drive of a pair,
causing it to access beyond an array boundary on the secondary interface.
This fixes it by using the new ide_get_paired_drive() helper instead.
Bart: patch description fixes
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Andrew Morton <akpm@osdl.org>
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
This adds a helper to get to the "other" drive on a pair connected
to a given hwif.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Andrew Morton <akpm@osdl.org>
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
arch/ia64/kernel/machine_kexec.c: In function `arch_crash_save_vmcoreinfo':
arch/ia64/kernel/machine_kexec.c:131: error: `pgdat_list' undeclared (first use in this function)
arch/ia64/kernel/machine_kexec.c:131: error: (Each undeclared identifier is reported only once
arch/ia64/kernel/machine_kexec.c:131: error: for each function it appears in.)
arch/ia64/kernel/machine_kexec.c:134: error: `node_memblk' undeclared (first use in this function)
arch/ia64/kernel/machine_kexec.c:135: error: `NR_NODE_MEMBLKS' undeclared (first use in this function)
arch/ia64/kernel/machine_kexec.c:136: error: invalid application of `sizeof' to incomplete type `node_memblk_s'
arch/ia64/kernel/machine_kexec.c:137: error: dereferencing pointer to incomplete type
arch/ia64/kernel/machine_kexec.c:138: error: dereferencing pointer to incomplete type
make[1]: *** [arch/ia64/kernel/machine_kexec.o] Error 1
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Tony Luck <tony.luck@intel.com>
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc:
net: libertas sdio driver
mmc: at91_mci: cleanup: use MCI_ERRORS
mmc: possible leak in mmc_read_ext_csd
make clean failed to delete a few files in
x86/kernel. This is because kbuild does not
see the correct/full kernel/Makefile.
As a workaround until the Makefiles are merged specify
the files to be deleted in the common Makefile.
Reported by Mike Galbraith <efault@gmx.de>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Cc: Mike Galbraith <efault@gmx.de>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
A sysctl method was added to enable and disable debugging levels. After
further review, it was decided that there are better approaches to doing this
and the sysctl methodology isn't really desirable. This patch removes the
sysctl code from 9p.
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
A small MMC driver cleanup.
Use the defined AT91_MCI_ERRORS in at91_mci_completed_command() instead
of specifying all the error bits individually.
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The exception path associated with an invalid ext_csd_struct returns
without freeing ext_csd.
Coverity CID 1909.
Signed-off-by: Florin Malita
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
This patch moves transport dynamic registration and matching to the net
module to prevent a bad Kconfig dependency between the net and fs 9p modules.
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
Loose mode in 9p utilizes the page cache without respecting coherency with
the server. Any writes previously invaldiated the entire mapping for a file.
This patch softens the behavior to only invalidate the region of the actual
write.
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
The 9P2000 protocol requires the authentication and permission checks to be
done in the file server. For that reason every user that accesses the file
server tree has to authenticate and attach to the server separately.
Multiple users can share the same connection to the server.
Currently v9fs does a single attach and executes all I/O operations as a
single user. This makes using v9fs in multiuser environment unsafe as it
depends on the client doing the permission checking.
This patch improves the 9P2000 support by allowing every user to attach
separately. The patch defines three modes of access (new mount option
'access'):
- attach-per-user (access=user) (default mode for 9P2000.u)
If a user tries to access a file served by v9fs for the first time, v9fs
sends an attach command to the server (Tattach) specifying the user. If
the attach succeeds, the user can access the v9fs tree.
As there is no uname->uid (string->integer) mapping yet, this mode works
only with the 9P2000.u dialect.
- allow only one user to access the tree (access=<uid>)
Only the user with uid can access the v9fs tree. Other users that attempt
to access it will get EPERM error.
- do all operations as a single user (access=any) (default for 9P2000)
V9fs does a single attach and all operations are done as a single user.
If this mode is selected, the v9fs behavior is identical with the current
one.
Signed-off-by: Latchesar Ionkov <lucho@ionkov.net>
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
Change the names of 'uid' and 'gid' parameters to the more appropriate
'dfltuid' and 'dfltgid'. This also sets the default uid/gid to -2
(aka nfsnobody)
Signed-off-by: Latchesar Ionkov <lucho@ionkov.net>
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
Create more general flags field in the v9fs_session_info struct and move the
'extended' flag as a bit in the flags.
Signed-off-by: Latchesar Ionkov <lucho@ionkov.net>
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
This patch abstracts out the interfaces to underlying transports so that
new transports can be added as modules. This should also allow kernel
configuration of transports without ifdef-hell.
Signed-off-by: Eric Van Hensbergen <ericvh@gmail.com>
Fix rebuild of kernel when there is no changes.
This happened for i386.
Using make V=2 hinted that the output files were
not assigned to targets - fixed by this patch.
Reported by: Boaz Harrosh <bharrosh@panasas.com>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
This patch:
- makes .gitignore files visible to git
- makes arch/x86/kernel/vsyscall_32.lds and arch/i386/boot invisible
Signed-off-by: Denis V. Lunev <den@openvz.org>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Almost identical except for the extra DR_LEN_8 and the different
DR_CONTROL_RESERVED defines.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Conflicts:
include/asm-x86/Kbuild
Same file, except for whitespace, comment formatting and the
.long/.quad delta which can be solved by a define.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Same file, except for whitespace, comment formatting and:
32-bit: if((unsigned int) addr >= (unsigned int) high_memory)
64-bit: if((unsigned long) addr >= (unsigned long) high_memory)
where the latter can be used safely for both.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Conflicts:
include/asm-x86/floppy_32.h
include/asm-x86/floppy_64.h
commit 554d284ba9 added _GPF_NORETRY
to floppy_64.h to prevent OOM killer on floppy DMA allocations.
Apply the same to the 32 bit variant.
Found during the attempt to unify the _32/_64 variants. Seperate commit
to document the resulting code change.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Same file, except for whitespace, comment formatting and the two variants
of fb_is_primary_device()
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Same file, except for whitespace, comment formatting and:
32-bit: unsigned long *virt_addr = va;
64-bit: unsigned int *virt_addr = va;
Both can be safely replaced by:
u32 i, *virt_addr = va;
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Same file, except for whitespace, comment formatting and the extra
function prototype usc_tsc_delay() in _32.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Auke Kok