For enhancing the 32 bit EBP based backtracer, I need the capability
for the backtracer to tell it's customer that an entry is either
reliable or unreliable, and the backtrace printing code then needs to
print the unreliable ones slightly different.
This patch adds the basic capability, the next patch will add a user
of this capability.
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
We have a lot of code which differs only by the naming of specific
members of structures that contain registers. In order to enable
additional unifications, this patch drops the e- or r- size prefix
from the register names in struct pt_regs, and drops the x- prefixes
for segment registers on the 32-bit side.
This patch also performs the equivalent renames in some additional
places that might be candidates for unification in the future.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
This patch defines frame_pointer() and stack_pointer() similar to the
already defined instruction_pointer(). Thus the oprofile code can be
written in a more readable fashion.
[ tglx: arch/x86 adaptation ]
Signed-off-by: Jan Blunck <jblunck@suse.de>
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
This patch improves oprofile callgraphs for i386/x86_64. The old
backtracing code was unable to produce kernel backtraces if the
kernel wasn't compiled with framepointers. The code now uses
dump_trace().
[ tglx: arch/x86 adaptation ]
Signed-off-by: Jan Blunck <jblunck@suse.de>
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Fix x86 oprofile regression introduced by:
commit c34d1b4d16
[PATCH] mm: kill check_user_page_readable
That commit reorganized tests for the userspace stack walking moving all
those tests into dump_backtrace(), however, dump_backtrace() was used for
both userspace and kernel stalk walking. The result is typically no
recorded callgraph information for kernel samples.
Revive the original function as dump_kernel_backtrace() and rename the
other to dump_user_backtrace() to avoid future confusion.
Signed-off-by: Gerald Britton <gbritton@alum.mit.edu>
Apology-from: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Fix the problem in kernel 2.6.15.1 (and early versions) that OProfile on
x86_64 does not correctly collect the stack traces for kernel functions.
The original code in valid_kernel_stack() in arch/i386/oprofile/backtrace.c
assumes that the frame pointer (headaddr) should be greater than stack
(i.e., regs).
This assumption is wrong for x86_64 because NMIs in x86_64 use a seperate
stack different from the kernel stack. Therefore, the variable stack now
points to some location on the NMI stack, which turns out to be at a higher
address than the frame pointer (headaddr) on the kernel stack. The correct
comparison here should be between headaddr and regs->rsp for x86_64.
Signed-off-by: Tong Li <tong.n.li@intel.com>
Cc: John Levon <levon@movementarian.org>
Cc: Philippe Elie <phil.el@wanadoo.fr>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
check_user_page_readable is a problematic variant of follow_page. It's used
only by oprofile's i386 and arm backtrace code, at interrupt time, to
establish whether a userspace stackframe is currently readable.
This is problematic, because we want to push the page_table_lock down inside
follow_page, and later split it; whereas oprofile is doing a spin_trylock on
it (in the i386 case, forgotten in the arm case), and needs that to pin
perhaps two pages spanned by the stackframe (which might be covered by
different locks when we split).
I think oprofile is going about this in the wrong way: it doesn't need to know
the area is readable (neither i386 nor arm uses read protection of user
pages), it doesn't need to pin the memory, it should simply
__copy_from_user_inatomic, and see if that succeeds or not. Sorry, but I've
not got around to devising the sparse __user annotations for this.
Then we can eliminate check_user_page_readable, and return to a single
follow_page without the __follow_page variants.
Signed-off-by: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Rename user_mode to user_mode_vm and add a user_mode macro similar to the
x86-64 one.
This is useful for Xen because the linux xen kernel does not runs on the same
priviledge that a vanilla linux kernel, and with this we just need to redefine
user_mode().
Signed-off-by: Vincent Hanquez <vincent.hanquez@cl.cam.ac.uk>
Cc: Ian Pratt <m+Ian.Pratt@cl.cam.ac.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
Arjan van de Ven