ath9k: Make sure we configure a non-zero beacon interval

This patch moves the sanity check on beacon interval
which was done only for mesh mode to all operating
modes just to be safe.

Signed-off-by: Vasanthakumar Thiagarajan <vasanth@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/ath/ath9k/beacon.c

@@ -674,13 +674,6 @@ static void ath_beacon_config_adhoc(struct ath_softc *sc,
 
 	intval = conf->beacon_interval & ATH9K_BEACON_PERIOD;
 
-	/*
-	 * It looks like mac80211 may end up using beacon interval of zero in
-	 * some cases (at least for mesh point). Avoid getting into an
-	 * infinite loop by using a bit safer value instead..
-	 */
-	if (intval == 0)
-		intval = 100;
 
 	/* Pull nexttbtt forward to reflect the current TSF */
 
@@ -745,6 +738,14 @@ void ath_beacon_config(struct ath_softc *sc, struct ieee80211_vif *vif)
 		iftype = sc->sc_ah->opmode;
 	}
 
+	/*
+	 * It looks like mac80211 may end up using beacon interval of zero in
+	 * some cases (at least for mesh point). Avoid getting into an
+	 * infinite loop by using a bit safer value instead. To be safe,
+	 * do sanity check on beacon interval for all operating modes.
+	 */
+	if (cur_conf->beacon_interval == 0)
+		cur_conf->beacon_interval = 100;
 
 	switch (iftype) {
 	case NL80211_IFTYPE_AP: