dma: sdma: Add imx25 compatible

imx25 did not work without a firmware previously.

This patch adds a DT compatible to pass the correct data with the
default script addresses for imx25.

Add imx25 compatible to the list of compatibles in the binding
documentation.

Signed-off-by: Markus Pargmann <mpa@pengutronix.de>
Acked-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Vinod Koul <vinod.koul@intel.com>

Documentation/devicetree/bindings/dma/fsl-imx-sdma.txt

@@ -1,12 +1,16 @@
 * Freescale Smart Direct Memory Access (SDMA) Controller for i.MX
 
 Required properties:
-- compatible : Should be "fsl,imx31-sdma", "fsl,imx31-to1-sdma",
-  "fsl,imx31-to2-sdma", "fsl,imx35-sdma", "fsl,imx35-to1-sdma",
-  "fsl,imx35-to2-sdma", "fsl,imx51-sdma", "fsl,imx53-sdma" or
-  "fsl,imx6q-sdma". The -to variants should be preferred since they
-  allow to determnine the correct ROM script addresses needed for
-  the driver to work without additional firmware.
+- compatible : Should be one of
+      "fsl,imx25-sdma"
+      "fsl,imx31-sdma", "fsl,imx31-to1-sdma", "fsl,imx31-to2-sdma"
+      "fsl,imx35-sdma", "fsl,imx35-to1-sdma", "fsl,imx35-to2-sdma"
+      "fsl,imx51-sdma"
+      "fsl,imx53-sdma"
+      "fsl,imx6q-sdma"
+  The -to variants should be preferred since they allow to determnine the
+  correct ROM script addresses needed for the driver to work without additional
+  firmware.
 - reg : Should contain SDMA registers location and length
 - interrupts : Should contain SDMA interrupt
 - #dma-cells : Must be <3>.

drivers/dma/imx-sdma.c

@@ -449,6 +449,7 @@ static const struct of_device_id sdma_dt_ids[] = {
 	{ .compatible = "fsl,imx51-sdma", .data = &sdma_imx51, },
 	{ .compatible = "fsl,imx35-sdma", .data = &sdma_imx35, },
 	{ .compatible = "fsl,imx31-sdma", .data = &sdma_imx31, },
+	{ .compatible = "fsl,imx25-sdma", .data = &sdma_imx25, },
 	{ /* sentinel */ }
 };
 MODULE_DEVICE_TABLE(of, sdma_dt_ids);